Chevy Colorado & GMC Canyon banner

Chevrolet Colorado / GMC Canyon Fog Light LED Bulbs! USA Made SLF!

66K views 150 replies 37 participants last post by  Diode Dynamics 
#1 · (Edited)



Colorado & Canyon Fog Light LED Bulbs






Diode Dynamics carries LED bulbs for replacement of your Chevrolet Colorado & GMC Canyon's fog lights, in all major sizes. They are available in HP, XP, and SLF styles. This will make your fog lights a nice bright white that closely matches factory-equipped HID lighting! Just simple plug and play, replace the bulb and you are good to go!

Diode Dynamics offers the brightest, highest-quality bulbs on the market. Your order will ship same day, and we're here if you need us for support and service. These LED bulbs are designed by our engineering team here in St. Louis, and every bulb carries with it a three-year limited warranty.

Brightness:

Diode Dynamics offers several brightness options so you can choose what fits you best. These options are listed by the design and the lumen output of each bulb, compared to the factory bulb.

HP48: 265 lumens. Slightly lower brightness than factory.

XP80: 510 lumens. Similar brightness to factory.

SLF: Street Legal Output. Much brighter than factory. These are bright! Made in USA!


Bulb Design

HP48: This bulb is designed with 48 Epistar 3014 LED chips. Thanks to the cap on the top, the light from this High Power Bulb is shined backwards and away from the bulb, not straight out. This means the output is excellent, because it uses the vehicle's housing completely, which then shines the light much more uniformly.

XP80: Each of the four sides of this bulb contains three 5W-rated chips, and the top is fitted with four more, under a projector lens. This is the brightest self-contained automotive LED bulb on the market, and is housed in an aluminum casing with a textured finish for maximum heatsinking properties.

These bulbs are made up of a quality plastic connector to slide right into the plug, as well as high durability terminals. A load resistor is embedded to prevent blowing the LEDs from voltage surge, and a diode is implanted to protect the LEDs from reverse polarity. The LED is wired for 12V operation, the kind found on all modern vehicles.


Included in your order is TWO BULBS (to fit your Chevrolet Colorado / GMC Canyon).


Diode Dynamics' products come with a 30-day satisfaction guarantee and a 3-year limited warranty.


Click below for more info or to order:


Diode Dynamics: Fog Light LEDs for 2004-2012 GMC Canyon

Diode Dynamics: Fog Light LEDs for 2015-2017 GMC Canyon

Diode Dynamics: Fog Light LEDs for 2007-2013 Chevrolet Colorado

Diode Dynamics: Fog Light LEDs for 2015-2018 Chevrolet Colorado










Click below for more info or to order:


Diode Dynamics: Fog Light LEDs for 2004-2012 GMC Canyon

Diode Dynamics: Fog Light LEDs for 2015-2017 GMC Canyon

Diode Dynamics: Fog Light LEDs for 2007-2013 Chevrolet Colorado

Diode Dynamics: Fog Light LEDs for 2015-2018 Chevrolet Colorado


If you have any questions, please don't hesitate to post, PM, email contact@diodedynamics.com or call: (314) 205-3033

*PM us for the free-shipping code* (U.S. forum members only)

Thanks for looking!
Nick C.





 
See less See more
2 4
#9 ·
Thank you for asking!

It's very common practice for most aftermarket lighting suppliers to provide a "calculated" lumen number based on an assumption of efficiency for the type of LED used and the wattage of the bulb.

For example, they might say, "high-power LED bulbs usually emit about 10 lumens per watt, so this bulb will be about 800 lumens!" This is a complete guess, and is likely completely inaccurate.

Here at Diode Dynamics, we measure all of our replacement lighting products using scientific grade equipment to provide accurate lumen ratings under normal operating conditions in your vehicle.

I suggest visiting the "LED Brightness" section of our research page here: LED Brightness - LED - Research to learn more about automotive lighting.

Our testing process is summarized in this video:



And finally, here's a demonstration video of a simple current test that compares our LED bulbs to something you might find from another supplier:



I hope this answers your question, and please feel free to give us a call if you would like to learn more: (314) 205-3033

Nick C.
 
This post has been deleted
This post has been deleted
#22 ·
DD, you should know by now.....pics or it didn't happen.

I didn't see any on your site, could you enlighten us as to how they look?



Diode Dynamics is pleased to announce a new color for our popular XML2 fog light -YELLOW! The XML2 utilizes genuine CREE XML2 components, for a true, measured output of 1,420 lumens. 100% plug-and-play. Sizes available include 9005, 9006, H8, H10, H11, H16, and PSX24W.

Thanks!
Nick C.
 
#30 ·
I know you have the HID conversions but will you ever be adding LED high beam replacements? I have all the rest of your LED's except for front turn signals which I hope to add shortly and I would really like to convert my high beams to LED. Thanks! Your products are very well made and so far very easy install.
 
#39 ·
I just got done installing the HID 5000k conversion kit which looks awesome with the XML2 Fogs Lights. Can't wait to check it out tonight.

Based on what I read below, Can I put the same XML2 LEDs in my high beams to even everything out? Is that correct? If so I am ordering the switchbacks and the XML2 LEDs for high beams today.

I also need the lic. plate leds to match the reverse lights LEDs that went on with the fogs. The stock lic. plate lights look very blah and outdated now.
 
  • Like
Reactions: Diode Dynamics
#43 ·
I would update your site so that when you buy the switchbacks for turn signals the required resistors are automatically added or just included in purchase and increase price to accommodate.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top